English
 
Help Privacy Policy Disclaimer
  Advanced SearchBrowse

Item

ITEM ACTIONSEXPORT

Released

Journal Article

The oxidation of sulfur(IV) by reaction with iron(III): a critical review and data analysis

MPS-Authors
/persons/resource/persons101355

Warneck,  P.
Biogeochemistry, Max Planck Institute for Chemistry, Max Planck Society;

External Resource
No external resources are shared
Fulltext (restricted access)
There are currently no full texts shared for your IP range.
Fulltext (public)
There are no public fulltexts stored in PuRe
Supplementary Material (public)
There is no public supplementary material available
Citation

Warneck, P. (2018). The oxidation of sulfur(IV) by reaction with iron(III): a critical review and data analysis. Physical Chemistry Chemical Physics, 20(6), 4020-4037. doi:10.1039/c7cp07584g.


Cite as: https://hdl.handle.net/21.11116/0000-0000-CE76-4
Abstract
The dependences on ionic strength of the hydrolysis constants of Fe3+ and of the first dissociation constant of sulfurous acid are briefly reviewed. The data are needed to derive from apparent stability constants reported in the literature the stability constants for the three iron–sulfito complexes defined by the equilibria (c1) FeOH2+ + HSO3− = FeSO3+ + H2O, (c2) FeSO3+ + HSO3− = Fe(SO3)2− + H+, (c3a) Fe(SO3)2− + HSO3− = Fe(SO3)3H2−, where Kc1 = 1982 ± 518 dm3 mol−1, Kc2 = 0.72 ± 0.08, Kc3a = 189 ± 9 dm3 mol−1 (ionic strength μ = 0.1 mol dm−3). The rapid formation of these complexes is followed by a slower decomposition leading to the formation of SO3− radicals; the associated rate coefficients are k1 = 0.19 s−1, k1a ≈ 0.04 s−1, and k1b ≈ 0.08 s−1, respectively. The subsequent reaction leads to dithionate and sulfate as products. Overall rates and product yields from a variety of studies of the slow reaction are found to be consistent with a mechanism, in which the production of dithionate occurs mainly by the reaction of SO3− with FeSO3+ and that of sulfate by the reaction of SO3− with FeOH2+ and/or Fe3+. The role of copper as a catalyst is also analyzed. Rate coefficients for individual reactions are estimated from the data at low pH (μ = 1.0 mol dm−3) under conditions where the 1 : 1-complex is prevalent. They are extrapolated to lower ionic strengths for an analysis of the data obtained at higher pH to explore conditions when reactions of the higher complexes become important. The overall rate and the product yields of the reaction depend critically on the pH, the initial ratio of S(IV) to Fe(III) and the ionic strength of the solution.