de.mpg.escidoc.pubman.appbase.FacesBean
Deutsch
 
Hilfe Wegweiser Datenschutzhinweis Impressum Kontakt
  DetailsucheBrowse

Datensatz

DATENSATZ AKTIONENEXPORT

Freigegeben

Zeitschriftenartikel

Influence of the dopant concentration on the morphology of holetransporting alignment layers based on a polyimide matrix

MPG-Autoren
http://pubman.mpdl.mpg.de/cone/persons/resource/persons48410

Meisel,  A.
MPI for Polymer Research, Max Planck Society;

http://pubman.mpdl.mpg.de/cone/persons/resource/persons48440

Miteva,  T.
MPI for Polymer Research, Max Planck Society;

http://pubman.mpdl.mpg.de/cone/persons/resource/persons48490

Neher,  Dieter
MPI for Polymer Research, Max Planck Society;

Externe Ressourcen
Es sind keine Externen Ressourcen verfügbar
Volltexte (frei zugänglich)
Es sind keine frei zugänglichen Volltexte verfügbar
Ergänzendes Material (frei zugänglich)
Es sind keine frei zugänglichen Ergänzenden Materialien verfügbar
Zitation

Meisel, A., Miteva, T., Glaser, G., Scheumann, V., & Neher, D. (2002). Influence of the dopant concentration on the morphology of holetransporting alignment layers based on a polyimide matrix. Polymer, 43(19), 5235-5242.


Zitierlink: http://hdl.handle.net/11858/00-001M-0000-000F-6517-E
Zusammenfassung
Investigations on hole-transporting alignment layers (HTALs) consisting of a polyimide matrix doped with hole-transporting materials (HTMs) at different concentrations by means of low- voltage scanning electron microscopy and atomic force microscopy are reported. These layers were recently used as HTALs for liquid crystalline polyfluorenes in polarized light- emitting diodes. For HTM concentrations below 15 wt%, phase- separation was found to be not significant, and the layer characteristics were dominated by the stiff polyimide matrix. These layers aligned polyfluorene very well, resulting in polarization ratios in electroluminescence of more than 20. On the contrary, the morphology was substantially altered at higher dopant concentrations. Moreover, microgrooves became visible after rubbing, indicating that the degree of imidization of the polyimide matrix was reduced. As a result, increasing the concentration of the HTMs above a certain level resulted in a dramatic decrease of the aligning ability of the HTAL. (C) 2002 Elsevier Science Ltd. All rights reserved.